HEPCO Model 8000-1
Revolutionary Axial Lead Cut & Form Systems
The HEPCO Model 8000-1
An Axial Lead Former That's EASY to Set Up
HEPCO COMPETITION STEP 1 Dial Lead Spacing Use jig and slide parts to set lead spacing. in .001" Turn dual arms - One each side. increments. Measure with ruler. Measurements/calculations needed to get results. Often, measure & reset because not correct. STEP 2 Calibrate Cut Length Can't do. Scale. Place component in jaws and turn knob until jaws touch component body. STEP 3 Dial Cut Length Set with jigs or blocks or dial, but calculate Shows below-body 1/2 body diameter plus distance from body dimensions on scale. to bend and subtract from reading, etc. STEP 4 Dial Body Clearance Slide and center transport wheels. Dial each side of machine. That's All There Is To It!! Still More Steps Needed!! Loosen series of set screws and re-tighten. Change entire transport wheel sets. Change die sets. Set clearances for lead diameter with shim stock Adjust die clearances for lead diameters Train employees how to use/calculate Re-train employees how to use/calculate
CONTACT YOUR SALES REP FOR A DEMO TODAY!
For more information: HEPCO, INC.
Phone:(408) 738-1880 - Fax:(408) 732-4456
http://www.hepcoblue.com -or- firstname.lastname@example.org
Copyright © 2010 HEPCO, Inc. All rights reserved.